Cut The Gutter

Switch to other side of the gutter and cut down the line until you reach the bottom again.

Cut the gutter.

If you have difficulty cutting with the tin snips make another cut 1 to 2 inches away from the cut line with the alternate hand snip. Start cutting on an outer flange edge with the pattern shears. Cut until you reach the bottom of the gutter. Use the old adage measure twice and cut once then turn the gutter upside down on the table and mark it all the way around.

If the section of the gutter you are discarding is on your left use the right hand tin snips and vice versa if the discarded section is on right. Tear the paper backing off the tape and lightly adhere one edge of the tape to the top of the gutter. Cut the tape with a scissors or a razor knife photo 2. Laying your gutter on the workbench measure off the amount of gutter you want to cut and mark it with a pencil.

Cut along the pencil cut line with a pair of aviation snips. Cut a four inch long notch to overlap and splice together gutter sections. Use a carpenter s square to get around to the bottom. Cut a two inch long notch in the front lip of the gutter with tin snips to join a rain gutter section with an inside or outside corner piece.

Roll the tape down the wall of the gutter pushing it firmly into curves and corners photo 3. Turn the gutter section over so that you can hold it by one side. Proceed to cut down along the side of the aluminum gutter repeat the process to cut down along the other side of the aluminum gutter.